The ESP Guitar Company

Can you share some info regarding the proper way to place the bridge, what I mean is: are the sattle screws heads should face the tailpiece or face the bridge pickup??? is the a difference in sound??? thanks:confused:...

on my mh 301. not like fret buzz, like unclean electric buzz. could this be because of my bad switch (see other thread)? or is it because i have active pickups?...

Hey everyone, i changed the strings on 2 of my guitars and i noticed the action is alot highter on the higher frets(12-24) then it is on the lower frets(1-12), but its fine from frets 1-12, i have a esp m-2, and a fender...

yes, i'm going to the neck-dive issue again... may the wood used in the neck (maple/mahogani) make the weight difference for EX/EXPs to be/not neckheawy?...

Hi chaps looking as the title says for a wiring diagram for my axe...I´m redoing the mess inside. The set up is LTD M-200 has a pair of Dimarzios humbuckers, a Steve Special at neck and a Evolution at bridge. Finally...

what kind of TOM bridge does it come with and could anyone tell me where i could get a suitable replacement for it?...

I'm looking for a wiring diagram for adding a coil tap to the humbucker of a guitar with 1 single coil (neck), 1 humbucker (bridge). I want the tap to remove the inner coil of the humbucker. I'll be using Seymour Duncan...

The MM-04 Control has 9 wires connected to it. 7 are in a row on the right side, 2 meet just below the volume adjuster. You really need to have one of these available to see how everything meets. I will list in order how...

I have a custom shop fender strat, which i loved playing until i got my m-ii a few months ago... since i got the esp, ive totally gone off the strat- i find it comparatively difficult to fret notes... the frets on it seem...

I am planning on changing out my bridge EMG (Eclipse II) for a passive pick-up. Is it possible to leave the neck active and the bridge passive? If so, Is there a wiring diagram that would make this easier? It looked a...

Hi, bought a new PH-600 a couple of months ago, great guitar, just been battling to get it to keep in tune. Had a hard time to set a decent action, but have settled on a bit of a compromise, slightly higher than I would like,...

Hello, happy 4th of July first of all. Both R3 and R4 nuts are 42.9mm, but with different string spacing. LFR models usually are stated as 43mm. Is it a choice of preferance or feel with the R3 and R4 or is one required over...

I just bought some Dunlop straplok's for my ltd m200fm and the instructions say to drill both holes with a 7/64" drill bit. How big are the holes already? Do I really need to drill them? I don't have any expirience with...

heyy on the edwards models, a lot of them have a floyd rose 1000 series tremolo. is this some sort of licensed trem or a different version of the original?:S...

hey i have a guitar that i want to use for drop b tuning (B, F#, B, E, G#, C# for those who dont know) and im just curious-but is it better to use a guage 13-56 set for that tuning? cuz my otehr choice is 10-56 but ive tried...