Profile Details
Latest Activities
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Well, I got the solderless kit, and the 3way tele from emg. Wouldn't you know it, same issue.   After my gig next friday, Im going to swap out the 707 from my RG, and see if I'm just hallucinating. I would have never guessed......MORE »
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Yeah, at this point, I’m thinking I should just buy the solderless kit, and the tele 3 way switch, and just start over. Although I’m still going to try to wire it exactly how it is in the diagram first. Really wanted to use......MORE »
Daniel P.

Daniel P. updated their profile

Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Ok, not sure if I have my meter set correctly, ( I have it set to 200k) but here are the results:  bridge pickup   middle:      neck:      thoughts? ......MORE »
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

And post 4 and 8 ARE bridged?!?! Is this a bogus wiring setup for the switch, or is this ok? I know there are quite a few different ways to wire emgs, and like I said, I’ve only done emg single bridge pickup installations in......MORE »
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Ok, I looked up a couple things about the wiring for the 3way. There should be wire connecting post 1&2, 2&6, and 6&5.  From what I’m looking at, there is nothing connecting post 2&6. Could this be the......MORE »
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Ok, I looked up a couple things about the wiring for the 3way. There should be wire connecting post 1&2, 2&6, and 6&5.  From what I’m looking at, there is nothing connecting post 2&6. Could this be the issue? ......MORE »
Daniel P.

Daniel P. replied to the forum post Gain issue with my new MH1007ET

Ok, haven’t found the actual issue yet,  it I did notice that when the 3way selector is in the bridge position, it is the lowest gain out of all the selections. So, it’s either the switch or the power lead from the bridge......MORE »
Comments