A panel to go on the back of my amp head.

KaliburKalibur
Updated
    Kalibur
    Does anyone know where i can get a vented panel to go on the back of my amp head? My amp is a tube amp so it shouldn't be a problem. Do you know anyone who makes them?
    Dislike (0)
    archives
      Share
    nwright
    nwright wrote

    Is this a mass produced amp?

    If so, contact the manufacturer?

    Reply
    Dislike (0)
      Bridge The Void
      Bridge The Void wrote

      If one was meant to be on the amp and isn't there anymore, then you should be able to conact the manufacturer for a replacement part, unless the amp in question has been out of production for a while and has no similarity to current models.

      Reply
      Dislike (0)
        xXxEvilCorexXx
        xXxEvilCorexXx wrote

        depending what purpose this pannel is going to serve you can make one out of some flat stock from a hard ware store or supply house.
        home depot has diamond plate you can cut to fit if you need venting you could use a heating register. whole thing would cost you like maybe $20-25 and some time.

        Dislike (0)
          load more replies (1 of 1)
          esp_gaijin
          esp_gaijin wrote

          Does anyone know where i can get a vented panel to go on the back
          of my amp head? My amp is a tube amp so it shouldn't be a problem.
          Do you know anyone who makes them?

          if you don't want to pay the expense of the original piece from the mfr of the amp, or it's an old unit and can't get the piece anymore,

          then just go to homedepot / lowes / etc., and look for some material that will suit your needs, and cut it to fit, etc.

          Reply
          Dislike (0)
            Post to Thread

            Cancel