standby switches

Updated
CAPTAIN SARG
ok im an amp head noob but how do i not get the tubes to pop i know its bad and could blow one up so can someone give the steps so this dosent happen thank you for your time
apprentice

make sure that your head is conected to cab with proper high quality cable.....and turn the power on.....wait about 30sec. then stand by.....and rock on!!
after rocking on....reverse order...first stby then power

CrugerD

^ but no need to wait 30 sec in between when turning off though.

Metfuk

^ but no need to wait 30 sec in between when turning off though.

No, but you shouldn't turn it off IMMEDIATLY. You have to wait for a few secs to prevent them from popping.

apprentice

^ but no need to wait 30 sec in between when turning off though.

yesyes! no need to wait when turning off......just the order....first stdby then power

No, but you shouldn't turn it off IMMEDIATLY. You have to wait for a few secs to prevent them from popping.

doesn't matter when turning off.......because the only purpose for the stand by button is that it prevents high currency going in the cold poweramp-tubes......prewarming and stuff:)

load more replies (1 of 1)
Post to Thread