killswitches
killswitches
If the diamater of the hole is say 8mm and the switch is 10mm in diamater you may need a reamer to just widen the hole a little. Another way is if you have a 8mm hole and a 6mm diamater switch you can get 2 nuts a 2 washers, put one nut at the rear and then a washer then put it in the cavity, then you can put the other washer and nut in at the front of the guitar and then you have it installed, well and good.
I have a problem with my EC-1K at the moment, it has a diamater of 8mm and the push pull pot i want for my JB is a 10mm diamater so i am gonna have to invest in a couple of files or try my best to get a cheap reamer to widen the hole to a 10mm hole, drilling can sometimes ruin the finish as it can chip and scar the finish arround the hole.
everytime i've installed one i've had to hit up the drill.