Heads and Combo's

Joe_BradburryJoe_Bradburry
Updated
    Joe_Bradburry
    this is probibly a stupid question, but does anybody know why the control pannels on combo's are layed out opposite from the head versions?
    Dislike (0)
    archives
      Share
    chevy Z 302
    chevy Z 302 wrote

    umm...because its more ergonomic.

    Reply
    Dislike (0)
      Joe_Bradburry
      Joe_Bradburry wrote

      yeah, i figured it was a retarded question. my bad. :P

      Reply
      Dislike (0)
        K1N5L4Y3R
        K1N5L4Y3R wrote

        Its Because they use the same circuit board for both versions, and on the combo's the controls are flipped because the board is upside down, ie the transformers and tubes hang down on a combo but on the head they are up the other way. its basically so they don't have to redesign the board for the combo.

        Reply
        Dislike (0)
          Joe_Bradburry
          Joe_Bradburry wrote

          oh, snap! i didnt think about that! but then again, i havent been doing a lot of thinking lately. :)

          Reply
          Dislike (0)
            Post to Thread

            Cancel