standby switches

CAPTAIN SARGCAPTAIN SARG
Updated
    CAPTAIN SARG
    ok im an amp head noob but how do i not get the tubes to pop i know its bad and could blow one up so can someone give the steps so this dosent happen thank you for your time
    Dislike (0)
    archives
      Share
    apprentice
    apprentice wrote

    make sure that your head is conected to cab with proper high quality cable.....and turn the power on.....wait about 30sec. then stand by.....and rock on!!
    after rocking on....reverse order...first stby then power

    Reply
    Dislike (0)
      CrugerD
      CrugerD wrote

      ^ but no need to wait 30 sec in between when turning off though.

      Reply
      Dislike (0)
        Metfuk
        Metfuk wrote

        ^ but no need to wait 30 sec in between when turning off though.

        No, but you shouldn't turn it off IMMEDIATLY. You have to wait for a few secs to prevent them from popping.

        Dislike (0)
          load more replies (1 of 1)
          Post to Thread

          Cancel