Tech Talk
Noob Question about Gibson Toogle Switch
Updated
When the Gibson Les Paul or the ESP Eclipse's toogle pickup switch is pointing down to the ground, is the bridge or the neck pickup in use?...
MORE »
ESP MII duncans trem or hum
Updated
Hi guys just wondering , I'm about to swap my JB duncan for a duncan distortion. It's on an MII with floyd (duh) , anyway should I get a trembucker or a humbucker ? what's in it originaly (the JB that is)
Thanks
Raf...
MORE »
EMG HZ Pickup Height
Updated
Right so i normally use EMG actives but my schecter Damien has passive emgs in it does the same rule apply regarding pickup height meaning do they have to be as close to the strings as possible
Used it at practice the...
MORE »
EMG PA2 with seymor dunkan????
Updated
Hello, I decided to install EMG PA2 guitar with passive seymor dunkan.
I can not find this installation scheme.
My question, is whether you think, it is worth and whether this installation will work good.i you deserve?
Thank...
MORE »
neck pick up is tilted in the pup ring
Updated
i have a cheap les paul copy, and the damn neck pickup keeps falling and tilting toward the bridge in the saddle, i cant seem to figure why it keeps doing it, is it the spring or screws?...
MORE »
Reindeer and Forest-G/GT history
Updated
Hello everyone.
I'm not sure if I'm posting in the right section but here goes
The Reindeer and Forest type guitars have been my favorite for some time now but I never found much information or history about them.
Anyone...
MORE »
Guitar sanding
Updated
Hey guys!
Do you think it's possible to sand a flamed maple top guitar without ruining the beautiful stripes on it?...ive got an LTD M-100FM...and im tired of the see through black finish...a natural finish would be...
MORE »
Pickup mounting
Updated
Hey!
I'm thinking of mounting my pickups directly into my guitar (tired of pickup rings).
Any advices? How should i do it? I have an LTD M-100FM
thanks...
MORE »
locking nut help
Updated
i recently got a mighty mite jackson neck of eBay , and i need a nut for it but i really know little about floyd locking nuts .
what i do know is that it has holes drilled through the neck and it is 1 5/8" wide.
so do i...
MORE »
Pickup ring screws for MII with EMGs
Updated
Hi,
I bought my first ESP last year, an MII Neck through with EMGs. Superb guitar which blows away all my Ibanez guitars (which I promptly sold). However I noticed that a couple of the pickup ring retaiing screws had the...
MORE »
Help with tune o matic bridge
Updated
Is there some standard height for it? Should the other end be higher than the other? My guitar is Esp ltd fx 400 and the other day i cleaned up my guitar before putting new strings on it.
One thing that i didn't realize was...
MORE »
Compound radius neck question
Updated
This might sound like a stupid question, but whatever :rollin
I have a hardtail bridge from a guitar that the neck was 12" radius. Would the same bridge work for a neck with a compound radius 12" to 16"?
Thanks in...
MORE »
Replacing fingerboard...
Updated
So I dig ebony fingerboards... Though my favorite guitar, which is the LTD FX-260sm I have, has rosewood. Also a while back I posted about a fretbar being warped... It has warped back up. I was thinking of replacing the...
MORE »
Poweramp/preamp help
Updated
My Peavey Classic 50/50 and modded ADA MP-1 just aren't keeping up right now in terms of volume at shows when I'm not being mic'd. I'm only using the left side of the Peavey and I have the volume knobs on the ADA and Peavey...
MORE »
Replacing fret wire
Updated
Does anyone know the approximate cost of replacing the fretwire on a guitar? Because I absolutely detest the Extra Jumbo frets on my LTD and would like to have something smaller....
MORE »