Any suggestions on how to tighten the plate on the input jack for an MH-201?
Any suggestions on how to tighten the plate on the input jack for an MH-201?
Hey guys! I'm looking to tighten up the input jack a bit. It keeps coming loose while I'm playing and it causes a bit of static to sound in the speakers and I'd like to get rid of it. I'm looking for any suggestions on how to keep it tight enough that I don't have to do it before and each show.
Thanks guys!
Thanks for the advice, but I think my wording might have been bad. I mean the actual jack attached to the plate. The nut that is attached to it comes loose A LOT and I can't seem to keep it from either becoming TOO loose or so loose that the nut falls off and my input jack wiggles around in the plate.
You can use a little loc-tite, but I would suggest removing the nut from the bottom side of the jack plate (and keep it!!) and put a rubber washer in there up against the metal one. Once the plate is back on and the outer nut is tightened (with a ratchet), the rubber will compress into the teeth of the metal washer and stay tight! :)
im guessing its like my mh400nt but i would say put a squirt of loc-tite on the threads and then tighten it down.